15 OCTOBER NEW ZEALAND GAZETTE 4123

Schedule

Civil Aviation Rules Part 119: Air Transport Operator – Certification, Amendment 2 which shall come into force on 3 November 1998.

Civil Aviation Rules Part 121: Air Transport Operations – Large Aeroplanes, Amendment 4 which shall come into force on 3 November 1998.

Civil Aviation Rules Part 135: Air Transport Operations – Helicopters and Small Aeroplanes, Amendment 5 which shall come into force on 3 November 1998.

These ordinary rules are available for inspection at the Civil Aviation Authority of New Zealand, 1 Market Grove (P.O. Box 31-441), Lower Hutt.

They may be downloaded from the CAA Internet page at http://www.caa.govt.nz or purchased from Publishing Solutions Limited, Freephone: 0800 800 359.

Dated at Wellington this 6th day of October 1998.

K. W. WARD, Director of Civil Aviation.

(CAA Docket No. 98/CAR/1317)

au7331

Electoral Commission

Electoral Act 1993

Cancellations of Registration of Political Party and Registration of Party Logo

1. Pursuant to Part IV of the Electoral Act 1993, the Electoral Commission resolved on 9 October 1998 to remove the New Zealand Conservative Party from the Register of Political Parties maintained by the Electoral Commission, pursuant to section 62 of the Electoral Act 1993.

2. Pursuant to Part IV of the Electoral Act 1993, the Electoral Commission resolved on 9 October 1998 to cancel the registration of the logo for the New Zealand Conservative Party and to remove from the Register of Political Parties maintained by the Electoral Commission, pursuant to section 62 of the Electoral Act 1993, the record of the registration of that logo.

Dated at Wellington this 12th day of October 1998.

DR P. HARRIS, Chief Executive, Electoral Commission.

au7458

Land Transport Safety Authority

Traffic Regulations 1976

Exemption From Specified Lighting Requirements of the Traffic Regulations 1976

Pursuant to regulation 90 (1) of the Traffic Regulations 1976, I, Jörg Simon Mager, Senior Engineer, hereby exempt motor vehicles of Classes MA, MB, MC, MD1, MD2 and NA from the requirements specified in Schedule 1, subject to the conditions specified in Schedule 2.

Schedule 1

Exempted Requirements

The requirements relating to visibility angles prescribed by the following regulations of the Traffic Regulations 1976:

• Regulation 59 (3) (b) concerning: Forward-facing side lamps
• Regulation 60 (2) (c) Rearward-facing side lamps
• Regulation 61 (2) (b) Stop lamps
• Regulation 63 (2) (c) Direction-indicator lamps

Schedule 2

Conditions

(i) This exemption relates only to the visibility angles prescribed by the regulations specified in Schedule 1 and does not exempt from any other requirements prescribed by these regulations;

(ii) This exemption only applies to vehicles where the lamps and their mounting locations are the vehicle manufacturers’ original equipment specification;

(iii) This exemption does not apply to vehicles that were modified from their state when manufactured if the modifications resulted in a reduction of the visibility angles prescribed by the regulations specified in Schedule 1;

(iv) This exemption does not apply to scratch-built low volume vehicles;

(v) This exemption only applies to vehicles that comply with all applicable requirements of the Transport (Vehicle Standards) Regulations 1990;

(vi) This exemption may be revoked at any time.

Signed at Wellington this 7th day of October 1998.

JÖRG SIMON MAGER, Senior Engineer, acting under the authority delegated to me by way of instrument of delegation dated 23 December 1996.

au7326

Exemption From Specified Requirements of the Traffic Regulations 1976

Pursuant to regulation 90 (2) of the Traffic Regulations 1976, I, Peter Waring, Senior Policy Engineer, hereby exempt the motor vehicle specified in Schedule 1 of this notice from the requirements contained within regulations 58 (1) and 78A (a) of the Traffic Regulations 1976, subject to the conditions specified within Schedule 2 of this notice.

Schedule 1

Vehicle Details

• Make: BSV Motors
• Model: Trika

Schedule 2

Conditions

1. A lap belt manufactured to an approved standard is fitted to the driver’s seat position.

2. The single headlamp fitted to these vehicles must comply with all other requirements of regulation 58 where appropriate.

3. These vehicles are fitted with side lamp’s which indicate the vehicles width.

4. This exemption may be revoked at any time.

5. A copy of this notice must be carried in the vehicle at all times and be readily available for inspection.